I created a template with a Slope/Elevation for the left side. Desired slope direction was towards the left side no further actions required.
I mirrored it to the right. And the Slope/Elevation direction was towards left though it should be to the right.
I got almost crazy trying to find what was going on.
Finally i found the solution.
By default the slope is towards the left side. To set it to the right the point that is attached to must have a positive offset from its previous one! If it is vertical a 0.00001 value is enough to turn the set the direction to the right.
Trimble should mention this at the manual. I lost 7 hours from my work trying to find a solution.
This problem was reported to a Trimble forum and was answered by Alan Sharp. The solution was the same. I should have checked there from the very first time.
No comments:
Post a Comment